| Titre |
STUDY OF A CENTRIFUGAL PUMP, ASYNCHRONOUS MOTOR AND INVERTER, USING HARDWARE IN THE LOOP SIMULATION CONCEPT |
| Auteurs |
SANYA MAX FREJUS O. [4],
|
| Journal: |
J. Rech. Sci. Univ. Lomé (Togo) |
| Catégorie Journal: |
Africaine |
| Impact factor: |
0 |
| Volume Journal: |
16 |
| DOI: |
|
| Resume |
This work is about a low coast application of Hardware In the Loop simulation (HILS)
concept to the study of a three-phase inverter, asynchronous motor and centrifugal
pump. It presents the realization of the rectangular control using a micro controller
(ATMEGA 168). The signals generated by the micro controller have been used to
program the parallel port of a computer. By reading the recorded bits of the parallel port
in LabVIEW software, the signals from the micro controller have been restored and
made available to the simulation model of the three-phase inverter, asynchronous motor
and centrifugal pump, made in advance in LabVIEW. These models realized in the
computer are then controlled by external signals coming from the micro controller. The
challenge was to be able to transfer signals from the micro controller to the model
lodged on the computer and perform a simulation like in classical case, where all the
system under study is simulated. We compare the results of our simulation with those of
classical simulation. We notice that both results match. |
| Mots clés |
ATMEGA168, Hardware In the Loop Simulation, voltage inverter,
asynchronous motor, centrifugal pump. |
| Pages |
223 - 236 |
| Fichier |
(PDF) |